شركة Henan Huawei Aluminium Co., Ltd جيدة في معالجة ألواح الألمنيوم / شرائط الألمنيوم لسنوات عديدة, قطاع الألومنيوم المحولات لأن متطلبات الصناعة مرتفعة نسبيًا, حتى في الإنتاج والمعالجة في نفس الوقت, يجب فحصها بدقة, من أجل التأكد من أن كل دفعة من البضائع رائعة.

ملاحظات حول معالجة شريط الألمنيوم المحولات
يتم عمل شريط الألمنيوم المحول بعد قص الآلة من لفائف الألمنيوم الأم, so need to pay attention to quality of the aluminum coil in aluminum strip processing, processing of raw materials from the first before the check, selection of high quality aluminum coil slitting processing, remove burrs. Strict inspection of surface quality problems, such as scratches, oil stains, burrs and other problems, will put an end to the problem of raw materials.
In the case of qualified raw materials, we should also pay attention to the following points:

Transformer aluminum strip processing notices 1.

Width tolerance control between 0.05–0.1مم, so after the operator set cutting units , after correction to production, absolutely can not happen the size of large deviation.

Transformer aluminum strip processing note 2.

Aluminum edge burr is mainly due to the reasons for cutting tools, so must make sure the cutting tools sharp enough, and tread the edge with special treatment.

Transformer aluminum strip processing notices 3.

Transformer aluminum strip for O temper, so in the packaging and moves to avoid the bump, after the aluminum strip will form pits in the surface, directly affect the usage of such strip.